5 Pcs 0.96 Inch OLED I2C IIC Display Module 12864 128x64 Pixel SSD1306 Mini Self-Luminous OLED Screen Board Compatible with Arduino Raspberry Pi(Blue and Yellow)

Started adding one of these to my projects because I like to see what is happening, simple to integrate and program, so displaying information on the screen is rather easy. I need to order some more because I have all 5 in use and so far no issues with any of them.

I use an OpenSprinkler controller to run my yard irrigation system. The controller has an OLED display on the front that shows the status of the system, but over time it gets burned in, making it extremely difficult to read what’s on the screen. These OLED displays that I bought are a drop-in replacement for the one that came with the OpenSprinkler controller, so they are a very cost effective and simple way to restore the OpenSprinkler controller to like-new condition. I opted to go with the blue displays instead of the white ones that would have matched what came with the OpenSprinkler controller, but I’m sure the white ones would work just as well. I’m very happy with the quality of the display… it’s very sharp and easy to read.

I've used these displays on several other projects, so I selected them again. The price is good, but not great. They work exactly as advertised. Note that some of the displays are monochrome (bluish green), but others have a few lines at the top that emit yellowish light. I like the ones that have a few yellow lines as you can highlight a title of whatever it is you're displaying.The only complaint I have is that Amazon does not include detailed dimensions of the part. I had to search other 0.96" parts (also from Amazon) to get the dimensions I needed. I integrate the display into a 3D printed housing. To get the front of the display flush with the housing, I needed to provide relief around the panel for a good fit. So I need all the physical dimensions.

Easy to read, easy to integrate. Easy to program, lots of open source libraries.Have fun!

These worked very well, although they are very fragile so don’t drop them.

These are neat little displays for a good price. Was pretty easy to get going on a Raspberry Pi Pico (RP2040). Display is clear and big enough to see text even when the characters are ~2mm high. Build quality seems good enough for a bare PCB; has a 4-pin I2C header and 2mm mounting holes.By default, the device address is 0x3c, but if you are good with a soldering iron, you can move a tiny SMD resistor to change the address to 0x3D; the spot is clearly written on the back of the PCB near the header pins.There was no documentation with the displays, so you are kinda on your own. But, using Circuit Python, and ADAFruit's bootloader and libraries, and then Googling around, I was able to get it working easily enough. I did have to add a couple 4.7kΩ pull-up resistors on the SDA and SCL lines (the little circuit board attached to the display in my pic).Following another reviewer's advice, I powered it by 3.3v from the RPi output. If you need a starting point (like I did), I've attached a picture showing it working and a screenshot of the basic code I used to get it running. There's probably better ways, but this is just what I did. Hopefully, those pics are allowed. If not, you might have to Google around. Just remember to set the GPIO pins for your I2C, device address 0x3c, and the display dimensions (128x64) where needed.

Worked well, installed in a rack mount 3d printed chassis for a Raspberry Pi 4B running Bookworm OS. Used Adafruit Blinka library to display RasPi status. As a note, I haven’t been smart enough to get it working on other Raspberry Pi’s with Buster OS. The problem isn’t the display, but the Blinka library needs a newer version of Python…

Nicely packaged! Worked with no issues. The OLED is very good. Pixels are clear