Motorcycle Highway Bar Switchback Driving Lights DRL Turn signal (White Amber LED for Crash Bars Harley Davidson Touring Bikes)

Your browser does not support HTML5 video.  They appear to be good quality. Both amber and white lights are bright. I have not installed them yet. After installing they are bright and should get other drivers attention

My replacements lights came and this time I tested lights before install, and again after installed on the crash bar. The wires are so very small that I used rubber grommets on the holes I put in the crash bars to protect them against damage during install, even though the first set showed no signs of the wire be rubbed. This will insure no rubbing against the sharp edge of the inside of the bar while ridden. Will complete the wiring this weekend.

These were less expensive that the XKGLOW brand. Adds extra visual for oncoming drivers, especially when making left turns. ( I left the factory signals on. ) I used doublestick tape on the inside instead of the supplied rubber gaskets. I thought they were a tad too thick. Chrome is a bit wavy, not high quality show chrome. Hardest and timeliest part was pulling the tank on my 07 FXDL to get to the harness for the running lights/turn signals. Soldered the wire once I stripped back a little insulation. Taped and scotchkoted. Great product so far, only time will tell. Only been on for about 500 miles.

I purchased these back in February, but did not get around to installing them until a few days ago. Unfortunately, one of them failed on my second trip with them installed.Since I have been unable to reach the seller for remedy, I assume that I will be eating this purchase.I would like to believe that all of the positive reviews on this product are legitimate and mine were the exception...

I bought this for a Fatboy with a Lindby mustache bar. The light is almost 5" long. It will not fit any segment of the Lindby bar as that highway bar curves more than the factory bar. If the LED light was less than 4" it might work. Quality build is good. LED's are bright. It just won't this this brand of bar. Returned item.Photos attached.

The wire is two small a gauge and the holes strip out when you are trying to bolt then up on the bars.

Your browser does not support HTML5 video.  They are nice, only that I might change - I will take it apart again and will solder proper wires starting from the light. They are too thin, I have no trust. But very good product for reasonable price. I do recommend! ......after a month one side stopped working. The wires are melted, though they were rounded by protection wrapping .

Great lights for the price!